Analytical Technology

ATIs A12-2 Wire UniSens universal 2-wire gas transmitter handles 28 different gases, providing the most economical and flexible gas measurement system available today. Combining universal electronics, bench calibration capability, automatic sensor verification, fault detection and alarming, and superior sensor technology, UniSens is your best transmitter choice.

GasSens is a flexible component system providing a variety of options to meet individual gas detection and alarm requirements. From chemical and petrochemical plants to food processors, the GasSens system can be applied to the simplest or most complex gas detection application. Economical and low maintenance, this system is your best choice for reliable leak detection.

The GasSens A14/A11 Modular Gas Detector is a flexible component system providing a variety of options to meet individual gas detection and alarm requirements. From chemical and petrochemical plants to food processors, the GasSens system can be applied to the simplest or most complex gas detection application.

The A24 Puffer is a portable, battery-operated instrument containing a gas generator and simple hand pump that provides the puff of air needed for sensor response checks. Puffers are water resistant for use in any environment and are designed to intrinsic safety standards. Generator cells provide hundreds of tests, with LED to indicate the remaining life of the generator cell. Generator cells are easily changed and the life indicator can be reset when a new generator is installed

ATI’s Series D12-IR gas transmitter eliminates the poisoning problems inherent in catalytic bead sensors. While Catalytic LEL sensors offer reliable service the presence of silicon vapors, hydrogen sulfide and halogenated hydrocarbons can quickly degrade sensor performance. Infrared sensing technology is not susceptible to these potential interferants, which means greater measurement stability and longer sensor life.

Our UniSens universal 2-wire gas transmitter handles 28 different gases, providing the economical and flexible gas measurement system available today. Combining universal electronics, bench calibration capability, automatic sensor verification, fault detection and alarming, and superior sensor technology. UniSens is designed for ambient gas monitoring in all kinds of industrial environments, in fact the UniSens transmitter can be used most anywhere that hazardous gas conditions might develop either through leakage or through natural buildup.

Combustible Gas Detectors are used in a wide variety of Industrial Plants to detect leakage or buildup before it reaches explosive levels. ATI’s Auto Test Combustible Gas Transmitter eliminates the need for frequent response checks. This transmitter performs an automatic gas test on the sensing element every 24 hours. The result is a combustible gas detector system with a level of reliability beyond that of any other system available. This daily sensor response verification is as close to a fail-safe detection system as you can find, with the added benefit of greatly reduced manual testing.

The Model A15/64 is an advanced electrochemical system for continuously monitoring dissolved ozone concentration in water. It uses a direct sensing ozone probe to measure dissolved ozone specifically, without interference from other sample components, such as residual chlorine. Engineered to perform reliably with a minimum of maintenance.

ATI’s Model A23-14 is a portable generator designed to produce an ozone gas concentration below 1PPM, which can be used for detector calibration at almost any location. Ozone generators are supplied in a durable molded case with sufficient space for outlet tubing and calibration adapters. The basic kit contains the generator, one 103 liter air cylinder with fixed flow regulator and 3 feet of outlet tubing.

ATI’s Series B12 Wet Gas System was developed to meet the need for reliable measurements in wet scrubber outlets for other gas streams that might be saturated with water vapor. Systems have been developed for monitoring strong oxidants (chlorine, bromine, chlorine dioxide, or ozone), acid gases (HCI or HF) and hydrogen. The basic B12 Wet Gas System consists of a loop-powered 2-wire transmitter and a corrosion resistant sensor specifically engineered to operate at 100% RH. Sensors are designed for direct insertion into vent stack, or may be used in a flowcell if sample can be pumped into the sensor.